| 拱形骨架模具如何现浇 |
| 添加时间：2019/6/1 16:38:36 浏览次数： |
| 现浇拱形骨架模具的设计是根据具体的高速公路培土地带以及高铁培土地带设计的，按照现浇拱形骨架模具的生产标准，钢板统一采用4毫米，上下拱为一套模具，模具重量大概在300公斤左右。 The design of cast-in-situ arch skeleton mould is based on the specific highway and high-speed railway land cultivation belt. According to the production standard of cast-in-situ arch skeleton mould, the steel plate is uniformly used for 4 mm, the upper and lower arches are a set of mould, and the weight of the mould is about 300 kg. 现浇拱形骨架模具耐磨好，强韧经用，具有杰出的强韧功能接受较大的冲击负荷，模具作业过程中在循环应力的长时间作用下，通常致使疲惫开裂。所以在使用现浇拱形骨架钢模具的时候，要注意每块模板直接对接的完整性，这样既可以保证生产出来的拱形护坡门完美漂亮，还可以增加模具的使用次数等。 The cast-in-situ arch skeleton die has good wear resistance, toughness and economic use. It has outstanding toughness function and accepts large impact load. Under the long-term effect of cyclic biaozhizh.37ix.com.cnshusongdaix.37ix.com.cnshusongdain.37ix.com.cnshusongdaip.37ix.com.cn zhongzhi.37ix.com.cndianliguan.37ix.com.cnstress during the operation of the die, fatigue cracking is usually caused. Therefore, when using cast-in-situ arch frame steel mould, attention should be paid to the integrity of direct butting of each template, which can not only ensure the perfect and beautiful arch slope protection door produced, but also increase the number of use of the mould. |
| 上一页 护坡模具放置时间 |
| 下一页 护坡模具pp粘度高,流动性好 |
Copyright © 技术支持：遨游网络